Weego JS12 Manuel du propriétaire télécharger pdf (Page 4)

best conductivity between your clamps, vehicle battery,

and vehicle (gure 1).

11. Identify the positive and negative terminals on your ve-

hicle’s battery. The positive terminal will usually be labeled

with a (+) and/or with a red coloring (gure 2).

12. Do not attach clamps to Weego yet! First, securely attach

the black clamp to the vehicle’s negative (-) battery ter-

minal, then the red clamp to the vehicle’s positive (+) bat-

tery terminal. Make sure the copper teeth of the clamps

are making good contact with the battery terminals for an

optimal connection.

13. Make sure the Weego is OFF.

14. Securely fasten the clamps into your Weego. Check that

you have a secure connection between the terminals and

clamps, and between the clamps and Weego (gure 3).

15. Place the Weego in a secure loca-

tion so it will not fall when starting

the vehicle.

16. Power ON your Weego (gure 4).

17. Start your vehicle (gure 5).

a. If after 3 seconds engine does not

start, turn key to OFF position.

b. Detach the Weego from the

clamps. Wait 60 seconds and then

follow steps 13-20. If problems still

persist, please see the

Troubleshooting section in your

Weego Owner’s Manual for other

possible causes (gure 6).

18. After a successful start, quickly detach the Weego from

the clamps.

19. Detach the clamps from the vehicle (gure 7).

20. You are now able to drive your vehicle. You should be sure

to run your vehicle for at least 15 minutes before shutting

it off again. If you have engaged the emergency brake,

disengage before driving your vehicle.

Red +

Start

Engine

Turn

Unit On

Red +

1 2 3 4 5 6 7 8 9 ... 15 16

Pas de commentaire

Weego JS12 Manuel du propriétaire Page 4